ONE:"Madame, there is but little to tell. You are indebted to that Paris firm for nearly a hundred thousand pounds. They call themselves financial agents, but they are moneylenders of the hardest type. Maitrank is as hard as your diamonds. And he has found you out, Countess."
TWO: His utterances on this subject [the existence of an external world] are perhaps chiefly to be found in the third book of his treatise On the Soul, beginning with the fourth chapter. On turning to them we see that he never separates existence from knowledge. A thing in actual existence, he says, is identical with the knowledge of that thing. Again, The possible existence of a thing is identical with the possibility in us of perceiving or knowing it. Thus, until a thing is perceived or known, it can only be said to have a potential or possible existence. And from this a doctrine very similar to that of Ferrier might be deduced, that nothing exists except plus me,that is to say, in relation to some mind perceiving it. (Aristotle, p. 165.)There it appeared that my papers were in good order, but at the same time I was informed that I was to be taken to the commanding officer at the station and could not be allowed to leave Bilsen for the present. I was escorted through the townlet, which appeared to be entirely deserted; but now and then somebody came to his front-door to watch the latest victim of the Germans being led past. At the station I was pushed without much courtesy into a keep where six other civilians sat, who had been picked up as being at large, and whose faces were now covered with a cold perspiration from fear, because they were firmly convinced that by and by they would be shot.
ONE:When I left I got a lot of addresses of relations in The Netherlands, and undertook to send a postcard to each of these. They also gave me an introduction to the proprietor of an hotel whom they knew, in which they asked him to give me a bed; and thus armed I succeeded at last. It was high time too, for at nine o'clock everyone had to be at home. In the hotel everything was dark, for there was no gas in the town. At last I could lie down on my bed, and had a good rest, although I could not sleep a wink. I was too tired and had seen and experienced too much that day.
TWO:Chuck-boring is employed in three cases; for holes of shallow depth, taper holes, and holes that are screw-threaded. As pieces are overhung in lathe-boring there is not sufficient rigidity neither of the lathe spindle nor of the tools to admit of deep boring. The tools being guided in a straight line, and capable of acting at any angle to the axis of rotation, the facilities for making tapered holes are complete; and as the tools are stationary, and may be instantly adjusted, the same conditions answer for cutting internal screw-threads; an operation corresponding to cutting external screws, except that the cross motions of the tool slide are reversed.
ONE:
TWO:(1.) Name five machines as types of those employed in the general processes of converting material.(2.) Name some machines, the object of which is to augment forceOne to attain speedOne directed to the guidance of tools.(3.) What is the difference between the hot and cold treatment of iron as to processesAs to dimensions? (4.)
