THREE:For disadvantages there is, on the other hand, a want of uniformity in fittings that prevents their interchange from one part of a line shaft to the othera matter of great importance, as such exchanges are frequently required. A line shaft, when constructed with pieces of varying diameter, is special machinery, adapted to some particular place or duty, and not a standard product that can be regularly manufactured as a staple article by machinists, and thus afforded at a low price. Pulleys, wheels, bearings, and couplings have all to be specially prepared; and in case of a change, or the extension of lines of shafting, cause annoyance, and frequently no little expense, which may all be avoided by having shafts of uniform diameter. The bearings, besides being of varied strength and proportions, are generally in such cases placed at irregular intervals, and the lengths of the different sections of the shaft are sometimes varied to suit their diameter. With line shafts of uniform diameter, everything pertaining to the shaftsuch as hangers, couplings, pulleys, and bearingsis interchangeable; the pulleys, wheels, bearings, or hangers can be placed at pleasure, or changed from one part of the shaft to another, or from [47] one part of the works to another, as occasion may require. The first cost of a line of shafting of uniform diameter, strong enough for a particular duty, is generally less than that of a shaft consisting of sections varying in size. This may at first seem strange, but a computation of the number of supports required, with the expense of special fitting, will in nearly all cases show a saving."The behaviour of the soldiers during the night, with very few exceptions, makes a scandalous impression.
19 August 2015, John Doe
Lorem ipsum dolor sit amet, consectetur adipisicing elit. Voluptatum, sit. Doloribus dolores neque eos. Velit eveniet, necessitatibus aut sit tenetur perferendis! Commodi pariatur dignissimos, quis sequi odit iusto cumque quod!
THREE:
THREE:
THREE:"It is possible. It is not for me to say. Only poor Leon must be avenged!"The third plan of boring with bars resting in bearings is more extensively practised, and has the largest range of adaptation. A feature of this plan of boring is that the form of the boring-bar, or any imperfection in its bearings, is communicated to the work; a want of straightness in the bar makes tapering holes. This, of course, applies to cases where a bar is fed through fixed bearings placed at one or both ends of a hole to be bored. If a boring-bar is bent, or out of truth between its bearings, the diameter of the hole being governed by the extreme sweep of the cutters is untrue to the same extent, because as the cutters move along and come nearer to the bearings, the bar runs with more truth, forming a tapering hole diminishing toward the rests or bearings. The same rule applies to some extent in chuck-boring, the form of the lathe spindle being communicated to holes bored; but lathe spindles are presumed to be quite perfect compared with boring bars.