ここから本文です
TWO:General Dauns army, numbering ninety thousand men, occupied very strong positions in a line extending north and south about five miles. On the 10th, Frederick, having obtained the needful supplies, resolutely, rashlybut, situated as he was, what the world deemed rashness was prudenceadvanced with but twenty-eight thousand men to assail this foe of ninety thousand behind his intrenchments. About five miles to the north, in the rear of the heights of Weissenberg, Frederick had a reserve of ten or twelve thousand men under General Retzow.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE: We went gravely at a slow pace,

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:This was on the evening before the review. On the morrow the Austrian accordingly rode upon the field. He had hardly arrived there when, just as the man?uvres were commencing, one of the aids-de-camp of Frederick galloped up to him and said, By the kings command, sir, you are ordered instantly to retire from this field.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:Under cover of these festivities important political matters were discussed. The question of the partition of Poland arose, and arrangements were made for another interview. Soon after this, Frederick sent to Catharine a sketch of a plan for partitioning several provinces in PolandRussia, Prussia, and Austria each taking a share. To which Petersburg, intoxicated with its own outlooks on Turkey, paid not the least attention.179 The second interview, of five days, commenced on the 3d of September, 1770, at Neustadt, near Austerlitz, which has since become so famous.Had it not been for him, things would have had a bad look by this time.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:Thus affairs continued through the winter. There were two frostbitten armies facing each other on the bleak plains. With apparently not much to be gained in presenting this front of defiance,496 each party breasted the storms and the freezing gales, alike refusing to yield one inch of ground.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.