THREE:
THREE:
THREE:I was not allowed to return by bicycle, and left it at a caf at the crossing of the roads to Tongres and Riemst. A couple of days later the Germans had already abstracted the tyres.Next in order are strains. As the cutting action is the source of strains, and as the resistance offered by the cutting tools is as the length or width of the edges, it will be found in the present case that while other conditions thus far have pointed to small proportions, there is now a new one which calls for large proportions. In displacing the metal between teeth of three-quarters of an inch pitch, the cutting edge or the amount of surface acted upon is equal to a width of one inch and a half. It is true, the displacement may be small at each cut, but the strain is rather to be based upon the breadth of the acting edge than the actual displacement of metal, and we find here strains equal to the average duty of a large planing machine. This strain radiates from the cutting point as from a centre, falling on the supports of the work with a tendency to force it from the framing. Between the rack and the crank-shaft bearing, through the medium of the tool, cutter bar, connection, and crank pin, and in various directions and degrees, this strain may be followed by means of a simple diagram. Besides this cutting strain, there are none of importance; the tension of the belt, the side thrust in bearings, the strain from the angular thrust of the crank, and the end thrust of the tool, although not to be lost sight of, need not have much to do with problems of strength, proportion, and arrangement.
TWO: